High quality Cisco CCDP 300-115 dumps pdf files and vce youtube demo free shared. New Cisco CCDP 300-115 dumps pdf training materials free download from lead4pass. “Implementing Cisco IP Switched Networks” is the name of Cisco CCDP https://www.geekcert.com/300-115.html exam dumps which covers all the knowledge points of the real Cisco exam. The best useful Cisco CCDP 300-115 dumps exam questions and answers free update, pass Cisco 300-115 exam test easily at first try.
High quality Cisco 300-115 dumps pdf files free download: https://drive.google.com/open?id=0B_7qiYkH83VROUdnZWRYLTJta1E
High quality Cisco 300-101 dumps pdf files free download: https://drive.google.com/open?id=0B_7qiYkH83VRWFlVNGtTZjU1MVE
QUESTION 1
An EtherChannel bundle has been established between a Cisco switch and a corporate web server. The network administrator noticed that only one of the EtherChannel links is being utilized to reach the web server. What should be done on the Cisco switch to allow for better EtherChannel utilization to the corporate web server?
A. Enable Cisco Express Forwarding to allow for more effective traffic sharing over the EtherChannel bundle.
B. Adjust the EtherChannel load-balancing method based on destination IP addresses.
C. Disable spanning tree on all interfaces that are participating in the EtherChannel bundle.
D. Use link-state tracking to allow for improved load balancing of traffic upon link failure to the server.
E. Adjust the EtherChannel load-balancing method based on source IP addresses.
Correct Answer: E
QUESTION 2
Routers R1 and R2 are configured for HSRP as shown below:
Router R1: interface ethernet 0 ip address 20.6.2.1 255.255.255.0 standby 35 ip 20.6.2.21 standby 35 priority 100 interface ethernet 1 ip address 20.6.1.1.2 255.255.255.0 standby 34 ip 20.6.1.21 Router R2: interface ethernet 0 ip address 20.6.2.2 255.255.255.0 standby 35 ip 20.6.2.21 interface ethernet 1 ip address 20.6.1.1.1 255.255.255.0 standby 34 ip 20.6.1.21 standby 34 priority 100 You have configured the routers R1 andamp;R2 with HSRP. While debugging router R2 you notice very frequent HSRP group state transitions. What is the most likely
cause of this?
A. physical layer issues
B. no spanning tree loops
C. use of non-default HSRP timers
D. failure to set the command standby 35 preempt
Correct Answer: A
QUESTION 3
Refer to the exhibit. Based upon the output of show vlan on switch CAT2, what can we conclude about interfaces Fa0/13 and Fa0/14? 300-115 dumps
A. That interfaces Fa0/13 andFa0/14 are in VLAN 1
B. That interfaces Fa0/13 and Fa0/14 are down
C. That interfaces Fa0/13 and Fa0/14 are trunk interfaces
D. That interfaces Fa0/13 and Fa0/14 have a domain mismatch with another switch
E. That interfaces Fa0/13 and Fa0/14 have a duplexmismatch with another switch
Correct Answer: C
QUESTION 4
When using EtherChannel misconfiguration guard, which technology is used to prevent this type of misconfiguration from affecting the network?
A. STP
B. port security
C. LACP
D. PAgP
Correct Answer: A
QUESTION 5
What happens if you apply this command andquot;vlan dot1q tag nativeandquot;?
A. packet will be dropped
B. packet go to defautl vlan
C. packet go to native vlan
Correct Answer: A
QUESTION 6
Refer to the exhibit.
What is the result of the configuration? 300-115 dumps
A. The EtherChannels would not form because the load-balancing method must match on the devices.
B. The EtherChannels would form and function properly eventhough the load-balancing and EtherChannel modes do not match.
C. The EtherChannels would form, but network loops would occur because the load-balancing methods do not match.
D. The EtherChannels would form and both devices would use the dst-ip load-balancing method because Switch1 is configured with EtherChannel mode active.
Correct Answer: B
QUESTION 7
A network engineer changed the port speed and duplex setting of an existing EtherChannel bundle that uses the PAgP protocol. Which statement describes what happens to all ports in the bundle?
A. PAgP changes the port speed and duplex for all ports in the bundle.
B. PAgP drops the ports that do not match the configuration.
C. PAgP does not change the port speed and duplex for all ports in the bundle until the switch is rebooted.
D. PAgP changes the port speed but notthe duplex for all ports in the bundle.
Correct Answer: A
QUESTION 8
Enablement of which feature puts the port into err-disabled state when the port has PortFast enabled and it receives BPDUs?
A. BPDU filtering
B. BackboneFast
C. EtherChannel
D. BPDU guard
Correct Answer: D
QUESTION 9
Refer to the exhibit.
Which EtherChannel negotiation protocol is configured on the interface f0/13 ?f0/15?
A. Link Combination Control Protocol
B. Port Aggregation Protocol
C. Port Combination Protocol
D. Link AggregationControl Protocol
Correct Answer: B
QUESTION 10
Which command globally enables AAA on a device? 300-115 dumps
A. aaa new-model
B. aaa authentication
C. aaa authorization
D. aaa accounting
Correct Answer: A
QUESTION 11
Which two statements about SPAN source and destination ports during an active session are true? (Choose two.)
A. The source port can be only an Ethernet physical port.
B. The source port can be monitored in multiple SPAN sessions.
C. Thedestination port can be destination in multiple SPAN sessions.
D. The destination port does not participate in STP.
E. You can mix individual source ports and source VLANs within a single session.
Correct Answer: BD
QUESTION 12
A Cisco Catalyst switch that is prone to reboots continues to rebuild the DHCP snooping database. What is the solution to avoid the snooping database from being rebuilt after everydevice reboot?
A. A DHCP snooping database agent should be configured.
B. Enable DHCP snooping for all VLANs that are associated with the switch.
C. Disable Option 82 for DHCP data insertion.
D. Use IP Source Guard to protect the DHCP binding table entries from being lost upon rebooting.
E. Apply ip dhcp snooping trust on all interfaces with dynamic addresses.
Correct Answer: A
The best and most updated latest Cisco CCDP https://www.geekcert.com/300-115.html dumps pdf training resources which are the best for clearing 300-115 exam test, and to get certified by Cisco CCDP.
